Recent content by turbostar99

  1. T

    New house, new dish project

    Flagstone's like the one's council's used to do the pavement's with. Put them down little bit of sand underneath and level off. Bolt your stand to the flagstone then put 4 concrete buiding block's on top of the flagstone. Easy to do quick and cheap B+Q sell them should cost not a lot more than...
  2. T

    Lightweight 80cm dish

    Next project, change the sky dish for a lightweight 80cm dish with 4 lnbs. Anyone know a aluminium one that's about the same weight as a sky dish or a clear plastic one should do. Thank's
  3. T

    42-39-28.2 east

    Technomate and a Protek recievers
  4. T

    42-39-28.2 east

    There you go, motorised with out the motor and it switches very quick too.
  5. T

    42-39-28.2 east

    From the left, we have 23.5,19.2,16,13,10,7east on 1.1m dish 42,39,28.2east on 88cm dish 5east,0.8,5west on 88cm dish I have 2 more dishes further down the garden one on 30west and the other 12.5,15 west. All working off Emp...
  6. T

    42-39-28.2 east

    Job done!! Many Thanks to everyone :-beer
  7. T

    Latitude and Longitude Settings

    i dont seem to be able to input full stops so would it be 51n 08w or 514n 088w Thanks
  8. T

    Latitude and Longitude Settings

    Hi, i'm stuck on my fs1 meter it say's to give long and lat settings of your location trouble is i dont understnd how to convert where it says long --w or --e lati --n or --s This is what dishpointer gave me for my location latitude 51.4263 longitude -0.8821 Anyone know how to convert this so i...
  9. T

    setting up uncommited 16x1 diseqc switch

    Look's like trial and error then. Handy to know there's not a default position. Many thank's!!
  10. T

    setting up uncommited 16x1 diseqc switch

    Thank's for the answer, quick question, what position would you be starting from? if there was a motor there you would set it at 1west with your lat. and long. I know you use diseqc mode. So that bearing in mind is there a default position for the switch. Using a 16x1 emp centauri switch and...
  11. T

    setting up uncommited 16x1 diseqc switch

    Hi, anyone know how to set up 16x1 uncommited switch using 1.2 dseqc motor, as my box does not have 1.1 diseqc command. Thank's
  12. T

    42-39-28.2 east

    Yep, that's sound's good. I'll give it a go on 36 then 28.2 only about 8 degrees away. Save moding the multi bracket, that's a pain and hopefully that should do the trick...Thank's
  13. T

    42-39-28.2 east

    I was even thinking of slightly off setting 39 east so 28.2 isn't quite as far apart from the centre arm. But i'm not to sure how strong 39 east is in southern england
Top