guest poster
registered
- Joined
- Aug 8, 2007
- Messages
- 989
- Reaction score
- 2
- Points
- 0
- Age
- 21
OK... go into Diseqc 1.2... use the controls to nudge the motor to ZERO on the motor's dial... you should have an option to recalculate - that should re zero your motor. Then check it again by go to reference or going back to USALS and with your settings & Thor still zero.. check Thor is zero .. (go to 5e then back to Thor just to make sure)... all the satellites will be at the right position on the motor dial so you can double check a few of them .. Try 13e does = 13e etc... (they wont work like that so don't expect any signals).
If that is OK then return your longitude to the correct one and Thor back to .8w. Then choose Thor again and line your dish up again* on Thor moving the whole assembly on the main pole and the dish up and down but do not alter anything else (your motor dial should show about 2e ….* make sure you have corrected latitude setting on your motor... and also that all the transponders or channels you use to locate each satellite are active ones.. see strongest signals list elsewhere on this forum)..
If that is OK then return your longitude to the correct one and Thor back to .8w. Then choose Thor again and line your dish up again* on Thor moving the whole assembly on the main pole and the dish up and down but do not alter anything else (your motor dial should show about 2e ….* make sure you have corrected latitude setting on your motor... and also that all the transponders or channels you use to locate each satellite are active ones.. see strongest signals list elsewhere on this forum)..