theboss4
Member
- Joined
- May 31, 2005
- Messages
- 51
- Reaction score
- 0
- Points
- 6
- My Satellite Setup
- -
- My Location
- uk
Hello
I have a strange problem with my Technomate 1000D.
My system
Technomate 1000D with Darkman patch
80cm dish
0.3 LNB Humax (and cheap 0.6)
Disequ Motor
lots of cable
I can't seem to get channels around 12300 frequency on any satellites.
Tried changing LNB, didn't help
Changed cable, didn't help
Changed way cable came into house, didn't help
Done factory rest, didn't help
Changed length of short cable from motor to LNB, didn't help
I have had a similar problem before. When wires from 2 different satellite dishes are fed in house next to each other, i.e wired for my sky box and wire for my Technomate, i could not get certain frequencies when both boxes were plugged in.
I can get all frequencies fine when motor is not connected, i.e from LNB to Technomate.
I also have a Skystar 2 and that seems to not like certain frequencies, if plugged into lnb out from technomate or from motor.
Any ideas?
I have a strange problem with my Technomate 1000D.
My system
Technomate 1000D with Darkman patch
80cm dish
0.3 LNB Humax (and cheap 0.6)
Disequ Motor
lots of cable
I can't seem to get channels around 12300 frequency on any satellites.
Tried changing LNB, didn't help
Changed cable, didn't help
Changed way cable came into house, didn't help
Done factory rest, didn't help
Changed length of short cable from motor to LNB, didn't help
I have had a similar problem before. When wires from 2 different satellite dishes are fed in house next to each other, i.e wired for my sky box and wire for my Technomate, i could not get certain frequencies when both boxes were plugged in.
I can get all frequencies fine when motor is not connected, i.e from LNB to Technomate.
I also have a Skystar 2 and that seems to not like certain frequencies, if plugged into lnb out from technomate or from motor.
Any ideas?