tornado-Odessa
Member
- Joined
- Jan 9, 2006
- Messages
- 34
- Reaction score
- 0
- Points
- 0
- Age
- 64
- My Satellite Setup
- Globo 6000
- My Location
- Odessa, Ukraine
@T_G,
Hi, I have read your post, and have the same problems as mhku.
I have a dm500s and a strong srt dm2100 motor. When I flash a new image like Gemini, and goto motor config, put in my cords. It does not work for me, I agree and would like for this to work automatically...after finding that it has not worked.. I go to the next motor config page, enter 13E and a strong transponder, adjust the stepping until I am satisfied, and store.
Then I do a second sat, lets say 28.2E, store save etc...I have tried gotoXX after that and it still fails....what have you learned that you can share on this..? drive to zero, also does not work, later this week my installer is coming over and I will try all this with the motor in front of me, and try and figure out what is going wrong...
In your post above I saw you said that you go in a tweak the gotoXX if your off a little on the sat.....
"for instance I will change 12 000 to 11 800"
Where is that, I don't see this... I only see 1/13.0E under the gotoXX box
with 1 as the number in the motor and 130 as the orbital pos.
Hi, I have read your post, and have the same problems as mhku.
I have a dm500s and a strong srt dm2100 motor. When I flash a new image like Gemini, and goto motor config, put in my cords. It does not work for me, I agree and would like for this to work automatically...after finding that it has not worked.. I go to the next motor config page, enter 13E and a strong transponder, adjust the stepping until I am satisfied, and store.
Then I do a second sat, lets say 28.2E, store save etc...I have tried gotoXX after that and it still fails....what have you learned that you can share on this..? drive to zero, also does not work, later this week my installer is coming over and I will try all this with the motor in front of me, and try and figure out what is going wrong...
In your post above I saw you said that you go in a tweak the gotoXX if your off a little on the sat.....
"for instance I will change 12 000 to 11 800"
Where is that, I don't see this... I only see 1/13.0E under the gotoXX box
with 1 as the number in the motor and 130 as the orbital pos.