LNB/Echostar problems

R

RENF4D

Guest
#1
I have a mono block lnb that switches between Hotbird and Astra. Since I did the OTA download for my 3000ip and then restored to the 900 version, I cannot get all the channels. It just says 'No Channel'.

I have the setting for the universal but don't get all the channels. I also use Disecq to switch between satellites.

Are there specific settings to use or do I need to change the lnb or receiver.

Many thanks :(
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,726
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
You need to setup the diseqC commands in the satellites/LNB menu to either A, or B, depending on which is which.

If you are pointing at Hotbird and Astra 1, try A for Hotbird and B for Astra, then if that doesn't produce results, try the other way around. :)
 
R

RENF4D

Guest
#4
Tried, but I only get about 20-50 channels on Astra & Hotbird. Nothing over frequency 11900.

Is there a setting for the lnb, or receiver, or at worst do i change the lnb.

Thanks :confused
 
Top