Matrix Reborn

mumtazrizvi

Regular Member
Messages
87
Likes
0
My Location
Pakistan
#1
Hi Dear Mates

Good Afternoon

Yesterday I converted my MRV to a Matrix Reborn using the
Cas Interface-II by updating the S/W MRT 1.8 but one sur-
prize I noticed in the Cam Menu there is "ZCAS" whereas it
has to be S/W 1.8 (just on experimental basis I tried it) On
every channel the cam says "insert smart card" any comment
in this regard will be highly appreciated.

With best regards/wishes

Mumtaz Rizvi :rolleyes:
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,700
Likes
1,287
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
Sounds like the conversion hasn't worked, are you sure it is possible?
 

mumtazrizvi

Regular Member
Messages
87
Likes
0
My Location
Pakistan
#3
rolfw said:
Sounds like the conversion hasn't worked, are you sure it is possible?
Hi Dear Rolfw

Good Afternoon

No I am not sure but I tried because I was quite sure
if something wrong will happend I can reconvert it back
to MRV thatswhat I tried it. I read that there is a new
S/W MRT 1.9 before applying it the MRT 1.8 has to be
put in the MR/MRV. Now I am looking for 1.9 but despite
spending 2 long hours could not get success.

With best regards/wishes

Mumtaz Rizvi
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,700
Likes
1,287
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#4
Try either fookfiles.com or Toecutter's Den, the link is in Nobbly's Big Links, Satellite Forums section.
 

rizla

Regular Member
Messages
29
Likes
0
My Location
Reading
#5
mumtazrizvi said:
Hi Dear Mates

Good Afternoon

Yesterday I converted my MRV to a Matrix Reborn using the
Cas Interface-II by updating the S/W MRT 1.8 but one sur-
prize I noticed in the Cam Menu there is "ZCAS" whereas it
has to be S/W 1.8 (just on experimental basis I tried it) On
every channel the cam says "insert smart card" any comment
in this regard will be highly appreciated.

With best regards/wishes

Mumtaz Rizvi :rolleyes:




Hi,



All you have to do is go into ZCAS menu. At the bottom of the menu list it says "Information". Select this option and type in a three-digit number that is included in the RELEASE-NOTES.txt of any Mrtv zip file. The number is "777".

After your receiver initiates the CAM again, it will no longer appear as ZCAS but MR T V1.08 or 1.09 if you use mrtv109. Although it seems to work even with my MR CAM it's unstable. After a few channel swaps something happens and the receiver says "Invalid CI module". If you have the original Mrv CAM I recomend you to use Mrv 2.19. Only difference I found is that Mrv 2.19 doesn't clear Cyfra+.


 
Top