MoTECK SG2100A

Messages
53
Likes
0
My Satellite Setup
GBSAT 2CI, 80cm Comag eliptical dish, Moteck SG2100A MOTOR
My Location
Nottingham
#1
Hi Guys,
I hope someone can help.
Have had the motor for 6 months no problems.
Today it will not move via the remote with the reciever, but have green light and will move manually.
Could it be a motor or reciever fault?
Have checked all connections to motor and reciever all seem.
Any help or tips would be well recieved.
Cheers!:(
 
J

Jeff_19341

Guest
#2
Motors sometimes forget where they are. Get your receiver to "Go to Ref" this should clear that type of problem.
 
Messages
53
Likes
0
My Satellite Setup
GBSAT 2CI, 80cm Comag eliptical dish, Moteck SG2100A MOTOR
My Location
Nottingham
#3
Hi Geoff,
Will try this later.
Thanks,
 

wolfav

Regular Member
Messages
470
Likes
0
My Satellite Setup
two sky+amstrad boxes
technomate5500ci+ with 80cm motarised dish irderto cam mr mrev +dragoncam blue tit numerous fun cards infinity pheonix compaq and dell on wirelessrouter
My Location
no mans land
#4
i had the same problem one of my cable covers was letting in a bit of water in bad weather a bit of tape sorted it out no problem
 
Messages
53
Likes
0
My Satellite Setup
GBSAT 2CI, 80cm Comag eliptical dish, Moteck SG2100A MOTOR
My Location
Nottingham
#5
Have just used remote control to move to Astra 28.2,. so at least will move with this.,
Just not when another channel on another satellite is selected.,
As before motor or reciever fault?
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,698
Likes
1,286
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#6
Have you tried what Jeff suggested? Often sending to zero or reference position will sort out these problems.

If not, then a hard reset on the motor itself may be necessary.
 
Messages
53
Likes
0
My Satellite Setup
GBSAT 2CI, 80cm Comag eliptical dish, Moteck SG2100A MOTOR
My Location
Nottingham
#7
:) Hi All,
Re set the motor underneath and re set using USALs function.
Even better than before, needed very little tweaking to lock on.
Just need T-Rex cam for more channels!!!
 
Top