steo69 said:
I'm using MAGIC MODULE LOADER. On the programmer the red and the yellow leds are always on. The green one is off. And there's really nothing to do to get it on and have access to programming.
HELP!!!
try another loader programme as i suggestes earlier. DREAM one is the one I used. this one worked for me. Try again and again dont give up you will get there eventually. Try this again
Turn off decoder,turn it back on, go into cam menu, if dreamload is there you should proceed to enter cam board into magic cam. you will see the lights on the board light up and stay on. Open up your magic loader programme, you will see connect and it should connect if everything is right to that point. make sure you are using a proper serial cable, and the port setting is on COM1. If you get connected you will see the other light on the board light up and the status bar on the programme rising to 100%. Ask on your receiver forum if this doesnt work. I had to enter a code to get my receiver into dreamload state, dont think you will have to do this as your receiver is in this mode already. Good luck