Hello all, I am totally new to all this and have read many articles and tutorial guides on this site.
my setup is to be the following.
technomate 5500 ci super
manhattan motor (HH140alu)
with 80cm channel master dish
from a well known map site i have obtained my longitude and latitude which are
latitude = 52.45 (north)
longitude = 1.7083 (east)
from the manhattan manual it says set the motor to latitude (52.45) and from the table supplied table (manhattan manual) set the dish elevation to 39.0 on the dish.
if someone much more expert than me can tell me if i am right up till now.
The thing that i am having trouble getting my head round is the due south setting. My technomate reciever supports USALS so is it best to use this instead of the disqec1.2 ?
I thinks i need to set the reciever to thor .8 degrees west and then turn the whole mount (motor and dish) until i recieve a good strong signal. then save this as my zero position satelite?
entering my lat and long into the technomate reciever this should then find all the other sats.
The trouble being that in my technmoate manual it says set the latitiude to (south of UKs latitude 515 north) and set longitude (london longitude is 0.001 west)
this of course does not in anyway relate to my lat and long of 52..45 and 1.7083 which i assume i shouild be entering? it also says if weak signal obtained adjust longitude upto 9 (exampe 0.002 or 0.003 etc...).
I really don't get this part of the setup or if i should be using usals or disqec1.2 .
I know this sounds confusing but i have tried to include everthing.
hope somone can help.
Ronbol
my setup is to be the following.
technomate 5500 ci super
manhattan motor (HH140alu)
with 80cm channel master dish
from a well known map site i have obtained my longitude and latitude which are
latitude = 52.45 (north)
longitude = 1.7083 (east)
from the manhattan manual it says set the motor to latitude (52.45) and from the table supplied table (manhattan manual) set the dish elevation to 39.0 on the dish.
if someone much more expert than me can tell me if i am right up till now.
The thing that i am having trouble getting my head round is the due south setting. My technomate reciever supports USALS so is it best to use this instead of the disqec1.2 ?
I thinks i need to set the reciever to thor .8 degrees west and then turn the whole mount (motor and dish) until i recieve a good strong signal. then save this as my zero position satelite?
entering my lat and long into the technomate reciever this should then find all the other sats.
The trouble being that in my technmoate manual it says set the latitiude to (south of UKs latitude 515 north) and set longitude (london longitude is 0.001 west)
this of course does not in anyway relate to my lat and long of 52..45 and 1.7083 which i assume i shouild be entering? it also says if weak signal obtained adjust longitude upto 9 (exampe 0.002 or 0.003 etc...).
I really don't get this part of the setup or if i should be using usals or disqec1.2 .
I know this sounds confusing but i have tried to include everthing.
hope somone can help.
Ronbol