burnet01
Regular Member
- Joined
- Sep 4, 2005
- Messages
- 36
- Reaction score
- 0
- Points
- 0
- Age
- 52
- My Satellite Setup
-
TEchnomate 1500 CI+ Super
80cm Dish
Fortec Start Universal Single 0.3 NF
- My Location
- Scotland
Hi,
I just bought my new satellite equipment. I got some problems setting the system up, as I am new in this I need some help.
After made all the connections; connect the receiver to the TV; I was trying to see if I get some signal before fix the dish to the wall. I am trying to catch Hispasat 30W so aim to 30W, but nothing, the quality signal was dead 1%. I tried to move the dish around a bit to other directions, with different inclinations but the quality signal always-dead 1%. I tried with all transponder in Hispasat but the problem was the same.
The level signal with the cable connected to the dish was 98% stable but something weird; I removed the cable from the dish and the quality signal started oscillating from 10% up to 60% (but never stable) and the level signal then died 0%. I connect the cable again to the dish and the quality signal died and the level signal went to 98%. I remove the F connector from the cable and made again thinking the problem was there but nothing, the problem remain.
What inclination should I give to the dish?
I would appreciate any advice.
This is my system:
Technomate 1500 CI Super
Fortec Start FSKU-V Universal Single LNBF 0.3 NF
80 cm fix dish
Latitude: 56.5 N
Longitude: -2.9 W
I just bought my new satellite equipment. I got some problems setting the system up, as I am new in this I need some help.
After made all the connections; connect the receiver to the TV; I was trying to see if I get some signal before fix the dish to the wall. I am trying to catch Hispasat 30W so aim to 30W, but nothing, the quality signal was dead 1%. I tried to move the dish around a bit to other directions, with different inclinations but the quality signal always-dead 1%. I tried with all transponder in Hispasat but the problem was the same.
The level signal with the cable connected to the dish was 98% stable but something weird; I removed the cable from the dish and the quality signal started oscillating from 10% up to 60% (but never stable) and the level signal then died 0%. I connect the cable again to the dish and the quality signal died and the level signal went to 98%. I remove the F connector from the cable and made again thinking the problem was there but nothing, the problem remain.
What inclination should I give to the dish?
I would appreciate any advice.
This is my system:
Technomate 1500 CI Super
Fortec Start FSKU-V Universal Single LNBF 0.3 NF
80 cm fix dish
Latitude: 56.5 N
Longitude: -2.9 W