JonnytheKid
Regular Member
- Joined
- Jul 5, 2004
- Messages
- 55
- Reaction score
- 0
- Points
- 6
- Age
- 52
- My Satellite Setup
- 2 Panasonic TU-DSB30 digib0xes, FTV cards, quad LNB, Zone 2 dish, & VCR (remember those?)
- My Location
- rural Northern Ireland
Hello everyone,
Thanks to Llew and rolfw for prior advice.
However, I was a little hasty in saying everything was sorted. My problem is this:
if my receiver (Echostar) is on Hotbird, and I switch to Astra1, then I get a "no signal" message, until I go into the "LNB setting" menu. I have Hotbird as LNB 1, and so on the LNB menu I set Astra1 as LNB 2. I press the "OK" button, and I get a "stored" message, but if I change channel, it (mysteriously) changes itself back to LNB 1, so to get Astra 1 back again, I must go back into the LNB setting menu and change it back to LNB 2 and so on, and so on... But shouldn't the sat switching button do all this by itself?
I'm not sure I've explained this very well. I have written down the monoblock specs and the LNB settings menu if that would help.
Jonny
Thanks to Llew and rolfw for prior advice.
However, I was a little hasty in saying everything was sorted. My problem is this:
if my receiver (Echostar) is on Hotbird, and I switch to Astra1, then I get a "no signal" message, until I go into the "LNB setting" menu. I have Hotbird as LNB 1, and so on the LNB menu I set Astra1 as LNB 2. I press the "OK" button, and I get a "stored" message, but if I change channel, it (mysteriously) changes itself back to LNB 1, so to get Astra 1 back again, I must go back into the LNB setting menu and change it back to LNB 2 and so on, and so on... But shouldn't the sat switching button do all this by itself?
I'm not sure I've explained this very well. I have written down the monoblock specs and the LNB settings menu if that would help.
Jonny