BrianJ
Member
- Joined
- Jun 13, 2007
- Messages
- 7
- Reaction score
- 0
- Points
- 0
- Age
- 59
- My Satellite Setup
-
Technomate 1500CI+ Super
Gibertini 1M Dish
Moteck SG-2100 Motor
- My Location
- North East Ireland
Hi All,
This evening I tried to do a blind scan on my motorised TM 1500CI+ Super but it would not scan.
The frequency display just flickers in the top corner and the progress display stays at 0%. I can't even do a transponder scan because when I try to enter the frequency it says "Invalid Frequency, please try again" even though I enter it correctly. It happens on all satellites that I try.
My software is up to date, v1.69 (08/06/2007), and I want to avoid a factory reset if possible.
Has anyone had this problem? Any help or advice would be appreciated.
All the best,
BrianJ
This evening I tried to do a blind scan on my motorised TM 1500CI+ Super but it would not scan.
The frequency display just flickers in the top corner and the progress display stays at 0%. I can't even do a transponder scan because when I try to enter the frequency it says "Invalid Frequency, please try again" even though I enter it correctly. It happens on all satellites that I try.
My software is up to date, v1.69 (08/06/2007), and I want to avoid a factory reset if possible.
Has anyone had this problem? Any help or advice would be appreciated.
All the best,
BrianJ