bureaucrazy
Member
- Joined
- Feb 16, 2012
- Messages
- 14
- Reaction score
- 0
- Points
- 0
- Age
- 55
- My Satellite Setup
- planning future installation of satellite TV
- My Location
- east of england
I just got a second hand vision v9 912 multiswitch for my multi receiver distribution project _www.vision-products.co.uk/assets/products/datasheets/V9-916.pdf. I understand that it can be powered by the connected receivers. I understand that the power input to the multiswitch is used to also power the lnbs when connected.
As a simple test to see if it is working, I connected my Triax SR110 receiver input to one of the multiswitch outputs but the power light on the multiswitch does not light up. Is the multiswitch dead? Or do I need to do something else to power this multiswitch?
The Triax SR110 input produces 18v 300ma supply (usually for lnb power) and the multiswitch says it consumes upto 160ma from connected receiver.
Is there a downloadable instruction manual online? There was no PSU supplied with the multiswitch.
Thanks for your advice...
As a simple test to see if it is working, I connected my Triax SR110 receiver input to one of the multiswitch outputs but the power light on the multiswitch does not light up. Is the multiswitch dead? Or do I need to do something else to power this multiswitch?
The Triax SR110 input produces 18v 300ma supply (usually for lnb power) and the multiswitch says it consumes upto 160ma from connected receiver.
Is there a downloadable instruction manual online? There was no PSU supplied with the multiswitch.
Thanks for your advice...