My friend have that receiver and he was watching coded channels but after factory defaults it is not opening anything so i am thinking that it needs patch to be enabled because most of technosat receiver need their patch to be enabled
After installing the new software from 14 Oct for starsat 220 ci the receiver booted ok and the software innstaling was ok but when I went to connect it to the TV it didn`t wanted to boot any more, it is not the first time that i was changing the software for my receiver. Is it only my receiver...
lolofoufou i think maybe with new boot we can fix the problem but it will be very hard because as I said before the flash is block and only changing the flash will fix the problem. as up to now I didn`t fix the problem.
did you found code menu
regards
hello to all. There are a lot of people which have the same problem i have starsat 220 ci which is similar to 190 it looks the same but it is with CI. I would like to give an opinion about this i have searched for a solution for this problem but i couldn`t find it. I think it was problem with...
thank you for the reply digital2 the problem is i can download freely softwares which are published up to september and after that it is immpossible to download. the progress bar of download program goes good but at the end while writing flash it stops and time out error appears. so because of...
have anyone succseeded to download new software to starsat 220 ci because for me it is impossible it gives me an "Time Out" error
Thank you for any reply
I think also that there is a problem with the software because it is not possible that that many people have bad cable when with that cable i have downloaded other software to the same receiver
regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.