Recent content by didineedthis

I am using the VIX 1.3 image on my VU+ Duo and it is the most stable image i have ever used, i normally go for the Dream Elite but i am very impressed with the VIX image, no green screens so far, unlike the dream Elite on my DM800

I have now managed to configure the satellites and everything is working fine, so i no longer require an installer so this thread may be closed.

not sure what it was to be honest , as i said, i just changed the settings and it worked for me. just glad its all sortet as you can only do so much reading before you go mad and your eyes feel like they are going to pop out. everything looks fine satellites are being tuned in with good quality...

Right then something to smile about at last. i have managed to locate thor 0.8 with the sat box and the sat finder meter, my setup is still the same, i still did everything as i was doing for the last 2 days but this time in the box settings for my configuration i changed the longitude from...

yes this is what i thought, thor is pre set in the satellite meters menu i have 0.8w thor set fta and 0.8w thor VH Az: -0.7 EL: 28.3 PO: -0/4

hi, yes i have tried that i have scanned the complete satelite with no sucess i have been checking the setting options in my digipro iiis meter, i have 3 option unit:dBmV unit:dBn unit:dBuV DO YOU KNOW WHAT THIS SHOULD BE SET TO ?

hi , yes i have read every tutorial i can find, i set everything up in a straight line pointing due south, i then sent the dish to thor 0.8w using usals i then find thor and tune in with my sat meter, good quality around 75% signal around 89%, i then tighten up and re check with the meter again...

Thanks again for your reply. sorry but it still not clear to me.so i need to 1. point my dish and motor due south then tighten it up 2. use Usals to find thor 0.8w 3. then do either a ?or b ? (this is what is confusing me i think ) (a) loosen the bracket that connects the dish to the motor...

just to get this clear, i send my dish via motor to thor 0.8w" using Usals ? do you mean the bracket that connects the dish to the pole ? swing the dish round to find thaw using my meter ? this part i understand lol.

hi, thanks for the reply, hi yes sorry it reads 55 on the latitude scale i cant find thor using Usals i have to locate it manually with my meter.

hi, thanks for your prompt reply, i think it is every satelitte that is not being tracked correct, i have the motorised dish set directly above my sly minidish and the angles are no were near the same.

Hi All, been having a nightmare trying to set up usals, i am using a TM2600 motor on a TD88 dish, my pole and mount is bang on level, cheched all sides with a level and also dropped a plumb line down the center of the ploe and it confirms it is level. i think i am having the same issues as...

Cut a long story short , i have installed a motorised setup haveing issues setting up the satelittes , "brackets and pole are plum " DISH - TD88 MOTOR - TM-2600 LNB - INVERTO BLACK ULTRA need some one position the dish and to configure and tune in the satelites on a dm800 payment by cash on...

ok thats settled it, motorised it is with the kit you sugested. thanks for your time and input once again , greatlly appreciated.

i have also been looking at the Lnb multi-bracket system for 13e,16e,19e,28.e, , as i also live on top of a hill and the wind does get a bit choppy up here when it does start blowing so a fixed bar might be a better option , how do motorised dishes do in the wind ? i just need to make my my mind...