Hi Vipersan, Ponny used the FAC.OPENBOX.SX6.v3.01.74.2014Aug08 firmware and you can find it e.g. at www.satshop24.com (Downloads). He also created special settings by the editor to realize the 2 MHz distance between some Ka band signals. I use the very new firmware because I cannot receive so...
Hi Vipersan, Ponny found the quartz inside the Inverto LNB (German forum) and may be it is a PLL based LNB too. I think he uses a special Openbox SX6 firmware to get the best Ka band results. My TBS-6983 card is supporting the very fast BLScan2 (e.g. CrazyScan or EBS Pro) finding about all close...
Hi Vipersan, the F15 "does not like" the low sr so much (may be the F16 works better) and there is a little difference of the frequency compared to the PLL LNB. May be the F15 will lock by changing the frequency 1 MHz. The Inverto LNB is ok.
Hi Vipersan, may be you can solve the problem by trying to lock the signal with CrazyScan again and again: I think the BER values are high because of Pilot switching off (the LNB is ok).
Hi, my Openbox SX6 receiver controls a DiSEqC 1.1 switch and it works well (Ku: "Tone A", Ka: "Tone B"). The TBS-6983 card did not control the internal switch properly (unknown reason) but works well with the Ka output.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.