Recent content by milkey

just update my mr cam with mr 110 +update seca keys file now have no seca idents but conax indents there problem with conax there codes are all 00 00s try to enter new codes cam resets back to oos again file was fron pay tv site used the fun 5 files to udate .Tryed the fun 6 files first but...

the 512 is the file size use the mr splitter with a . bin file to make the file size you need I also had the same proplem with a bad file i downloaded tried another source worked fine take alook at this site http://www.la-cafetera.com/matrix-cam.htm ive not used any thing from there yet but may help

your Two fun card 6 (ATMEL AT 90S8515 8Kb Flash) are to small to hold the mr1.081-1024 files you need the files 512 should be four of them 1. install on fun card 1 upload flash+mr.512 file1 2. install on fun card 2 upload flash+mr.512 file2 3 delet 2 fun card then do same with file 512 3+4

can now decode most channels with my MR 1.55 CAM but still a few with weak signels due to 80 cm dish carnt lock onto them

good news can now watch most channels on hipsat with just my MR CAM 1.55 still a few with weak signals dont decode only got 80 cm dish

hi am still new to all this but were can i find this file Program the ATMEL (90S8515/35) on your Funcard or Jupiter2 card with the > mickey4in1V44.hex and the EEPROM (24C64) with one of the .bin files from > k41.zip using ISVEdit V 2.2 _is the file k41.zip have not been with any of the 6in1...

thanks for help works fine reading an old ondigatal or phone cards but need to find the right loader flash for the infinerty usb to read cards the cards work that i programe just mkf4.4 wont read them without the right loader flash any ideas

SELECT CAM MR 1,05 THEN SETUP CHANGE NAGRA BOX KEY NEXT MENU HSA AT TOP BOXEY:7B7BC3FF-2B78786F CAN THEN ENETER A 3 DIGET NUMBER EACH TIME I ENTER 3 NUMBERS PART OF THE ABOVE KEY CHANGES THEN GET OPTION TO SAVE 123=7B 124=7C 125=7D IS THIS HOW I ENTER NEW CODES FOR NAGRA AND IS SO IS THERE A...

I HAD SAME PROBLEM USING 3 5IN1 FILES TO UPDATE FIRST 2 WOULD LOAD NO. 3 WOULD FAIL. SO I USED THE 4IN1 FILES 6 OF THEM WORKED FINE

hi am new to this on my cam access using a MR 1.05 WHAT IS THE Nagravision (with selectable BoxKey) FOR ANY HELP WOULD BE NICE

yep can read the card and and programe with infinety usb then sellect phenix baud rate 3.58 then when i try to use any other softwere get a carnt connect porrt may be in use

both usb and serial leads connected blue light on in nornal red in phenox mode trying to use mkfv4.4 click connect get message there wasa problem connecting to your card. port may be in use or settings incorrect

not sure all new to me

keep getting com port problem when in phenox mode using mkfv4.4 com port not found or may be in use carnt but works fine with inferty soft were to loads hex files