Recent content by Rock39

All good! Ordered a 4 outlet amp to leave the option of adding extra sets if needed – works fine, assume the issue was with a powered amp conflicting with the 9v from the R2 output….anyway thanks for the help.

Thanks - have ordered the distrubition amp you mentioned, will report back when I get it installed! Yes.. setup ok in the installers' menu, hopefuly this will do the trick.. Cheers,

Can anyone one advise on the correct distribution amp to use for connecting two extra TV’s to a skybox – both controlled with magic eyes? I have a coax from the RF output on my skybox which runs to my loft, there it joins with a second cable that returns the signal to second TV on the ground...

Sorted..with a reset of the dish & a rescan. Thanks again !!

Re-scanned, but no progress, when the wind stops howling (& daylight) i'll check the dish & see if that is the problem.

OK, just set the Echostar to rescan 13°E - noticed the signal had dropped quite a bit, the dish is in an exposed area & it is stormy night so might be the problem. Anyways, give me time to cool my fustration & go for a cold one...! Thanks.

Thanks Mikkha, got the file but no progress..? Getting a "No Signal or PMT not found & update file CAIDS.XML" message.. When I connect the cam in the Cas studio & on lookong in the CONFIG/CAIDS/ section I see a CAIDS.XML file can you tell me if I should update this - I assumed if it needed...

In configeration I have set caids file to caids, emulators on, N2 au on, & cw off?

Updated the .bin OK, now getting .. No Signal or PMT not found & update file CAIDS.XML ??

Tried a reboot & removing and re-inserting the cam but no joy..going looking for a .bin file ..will report back, Cheers,

Trying 13°E

Thanks got that..updated the cam ok but I am obviously missing something cause all I get is 2 messages i.e. “reading smart card” followed by a “Scrambled signal” ? Read a thread and as recommended -under cas I have all irdeto, viaaccess set to on, in configeration I have set caids file to...

Please excuse if this is a stupid question.. (just took delivery of a Diablo & cas3 so early days), but I just downloaded a underworld151.dup file.. if I update the cam will this also update the .bin file or do I need to look for this as well

Thanks for that Topper, I guess it's a Diablo CAM & a CAS programer request in a letter to santa then... Cheers, Rock39

I've been reading around & see that the abracadabra is only for use with an echolink 3020? Now with things being tight this looks like a cheeper option than the purchase of the diablo & a cas but I'm getting more confused by the minute..? Anyone using a abracadabra who can point me to a link on...