Recent content by srood123

hi again I want just 2 know when you say, 22.5 for dish, isit the satellite dish or the motor angle???? As I said if I put the motor angle on 51.5 which is london latitude and the satellite dish on 22.5 degrees should be fine???!!!!. Is this correct or not???!!!!!

hope for answer!!!

Hi, I am trying to set up a DisecqC 1.2 H-H Motor and having a few problems. - when testing the receiver is set to default and so is the motor. -when the LNB cable is connected from the LNB to the motor (to the bit that indicates LNB) the motor is not working at all. -however, when this...

thank you for all your help, I think you have sorted my problem, any way I understand much better now thanks alot

HI again thank you for your answer. Using the formula I have calculated the dish elevation to be as follows Stab Motor HH120 equals = P - ( 60 - locatio latitiude) = 39 -( 60 - 51.5) = 30.5 so the dish angle should be 30.5 for london. Is this correct or should I use the one You have given...

havent got any answer :(

The dish is Global Orbit 80cm. I live in south west london and the pole is set up ok (as far as i know)

hi there, My motor is STAB Motor HH120. On the motor there are two scales. One says latitude and the other elevation (from what i have understood from the instructions it says: For London, latitude 51.5 and the elevation 39.0. It gives a formula to do a calculation. The formula for STAB Motors...

Hi everyone I hope there is some one who can help me. I want to install my satellite dish with motor. I live in London, and I need help with how to put the satellite dish angel and the motor angel. Please if there is any one from London, who has put the satellite dish setup please help me...

please how can load keys to my echostar DSB-808 2Ci viaccess ?? please help me if u can thank u

U are a star thank u. But do I need any new software for my cam ? cuz it was MRV2.25 and UCAS 3.1. Or after erasing should go back to the original software?

thank u mate,, my friend he has cas interface2 ,, so i can borrow it now, if u just tell me how 2 do it ,, thank u

Stevo , thanx alot. My cas 3 is comming after tommorow so ill try it , but could u give instructions how to do it . I mean when i use the cas interface3 or its not possible ??

Hi everyone I did some stuped thing yesterday, i had matrix revulotion cam with MRV2.25 software ucas3.1 , and i updated firmware with my laptop and it was mrb300 and my cam was locked, because i wanted to go back to mrv225 but it was allways error. when i tried to opend so i used zcas2ucas file...

Hi everyone I did some stuped thing yesterday, i had matrix revulotion cam with MRV2.25 software ucas3.1 , and i updated firmware with my laptop and it was mrb300 and my cam was locked, because i wanted to go back to mrv225 but it was allways error. when i tried to opend so i used zcas2ucas file...