Vipersan gives a right answer ( I'm mad ) and guesses in the right direction
But St1 hit the clue .
I dont want to have a larger dish , just want to beat my free time and do things that maybe are not done before ( by amatures )
I started with 2 Triax TDS64 dishes set to zero elevation , for that I have to cut a part of the poleclamp .
Than attached them opposit at a tube to find the angle between the feedhorns with enough room for 2 more feedarms .
Now I could make the quatro-feed and 4 long neck feedhorns .
They are inside not all the same , could be a issiue to solve later .
To look it like a four leaf clover , I made a cross pole at a temporary stand with a fine elevation adjuster , later I noticed thats a bad idea since each dish must be optimised single .
Its easier to do when they are horizontal or vertical .
Pointed the set to 19.2º E and found a lot off signal but with bad quality , but it still gives me a picture .
As you can see there where bad weather conditions and I run out of time (have to leave the house for a celebration)
To set each dish to the optimum , I gonna turn the cross to upright .
When each dish is proper set I want to remove the feedarms and replace them for a tube from teh centre off the cross to the centre bolt at the quatro feed .