VERY, very nice... good job!After many months, the LNB Changer is now installed (I was a bit lazy til now....), everything is working well.
View attachment 109629
View attachment 109630
PS: The Laminas' LNB Changer has been removed instantly, the antenna is too "light" from my point of view and signal is not stable during wind conditions (even with low speed wind).
I do love to to see pictures of that lnb changerI wake up this post because i am finalize my positioner software .my friend Cardiff has build an lnb changer and i manage this device with my positioner !
i put east west and store command in diseqc 1.2 mode.
what is Go to Reference Position -- E0 30 6B 00 for ?
where is reference point , middle or limit ?
it s satellite garden of Cardiff (you post with him earlier in this thread)
View attachment 126814
Love to see the details inside the rotorI increased the rotation of the disecq "rotor" to about 350 °
Cardiff
At most boards my name is Trust , for some reason I could not register here with that name , so I used Trust1
trust or someone else ! Did you read firmware in rotor or positionner ?
On different view about Diseqc Motor internal pictures its seems it’s the same chip!!
I tried to read the holtek 48r50 but unsuccessfully.
i am curious to see how they have managed diseqc command .
About those commands , here you see a lot of info . https://de.eutelsat.com/en/support/technical-support/diseqc.htmltrust or someone else ! Did you read firmware in rotor or positionner ?
On different view about Diseqc Motor internal pictures its seems it’s the same chip!!
I tried to read the holtek 48r50 but unsuccessfully.
i am curious to see how they have managed diseqc command .
...about gotox.x command :
as i see on my receiver it s different from eutelsat datasheet !
(For the test results: see the links...)The GotoX command always starts with E0 31 6E ..,
....
in the dvbdream program I notice that two different ways are used to turn left or right from zero, for different diseqc motors:
motor:_______________________to the left (+ no. degrees)____________to the right (+ no. degrees)
STAB and SM3D12____________Ex xx_______________________________Dx xx
SG2100_______________________Ex xx_______________________________0x xx
Geotrack H120 and generic____Fx xx (counting back from FF FF)____0x xx