Recent content by hfathollahi

Thank you for your suggestions , but they don't work for me

Dear friends For pic programming ( JDM ) , are there any cases that the level of RESET signal ( MCLR ) MUST be 5v and not higher than that (13v) May be some kind of chips or cards need only 5 volt reset signal . Thanks

Dear M8s I am attaching a new software for recovery of those titanium cards that do not sent ATR information to pc at the time of programming. I have not used this software and be careful of using it .please reply to my post if you tried it . The text file in the attached zip is in Spanish...

Dear rolfw I’m on travel now , So I can check after coming back home . Thank you for your suggestion .

In my programmer , power only supplied through usb cable , so there is no chance to check another alternative . Thanks

It doesn’t matter of the software I use for writing on my card ,because all softwares hang on sending trap code . Thanks

Unfortunately your suggestion did not work for me .I think my card has been killed . Thank you for your help. Behzad

I'll check it soon and be back . In WB-ELECTRONIC site , there is a useful software tool that we can see if INFINITY USB / PHOENIX in phoenix mode is ok or not . the result was O.K for my programmer . So the problem can be from the software or my titanium card . I hope my card has not been...

Thank you for your all support , but no success . I put the carde in the programmer for three hours while titaniumcardprogger was running , but no result . Also as I said before, I used titanium os updater and nothing more , because it hangs on “ Trapping titanium card ….Please wait “

As I mentioned in my first post : 1-I have checked disabling FIFO , but no success 2-at first I used titaniumprogger 1.10 and then the older versions

Dear M8 I tried to program a new titanium card for the first time with an INFINITY USB/PHOENIX programmer ( phoenix mode 3.58 Mhz) according to the following steps , but without success (also the software installed on XP windows) : 1- after connecting the programmer and running...

Thank you all

Hi There are many channels for stream in http://www.lyngsat.com/dig/stream.shtml , Are you sure all of them can be opened using 6in1 files found in web sites ?

Thanks lee

Thanks Beech Beech ,If possible please mention the names of these channels . In addition I have a HUMAX 5400Z patched with the latest firmware and I use a funcard for opening channels .