dear members,
i am having trouble with some channels on hotbird running a cryptowork cam, problem is when i watch a channel without the cam its very clean, but once i insert the cam the picture is very jerky even on Free to Air channels.
any ideas???
cheers
Dear all.
I have updated my xcam with firmware 1.29 and k@ys from HB, i have notice a few channels not working ie Disco%ery....... tp@ works fine...
any ideas
wingman
Jason
I have a fortec star too and recieving hotbird6 and astra. I am using 2 LMB`s on one 90cm in a fixed position and it seems fine so i dont think you need a motorized dish. The hotbird lmb is positioned in the center of the dish and I have astra on the left handside (if looking in front of...
thx Rivzi
Its strange, because I notice it happened when I watch freeview channel (game network) WITHOUT the cam inserted it fine, but WITH the cam inserted its has no signal. I have tried to reset the STB and its the same. I can see the signal bar at 80% full then it loses the channel "no...
Hi there,
I have a Fortec Star 5100 reciever, when I insert the xcam the satellite signals are being lost on abot 80% of the channels. Could it be compatibility issues...any ideas???
thanks
Dear all,
I am new to satellite programing and just got a xcam with cas interface 2 with add on. I have put the xcam to virgin mode on block 2 and installed the firmware, must I again put the xcam in virgin mode on block 14 to update the softkeys???
many thanks
wingman.
ps> I have another...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.